External Cts Log Destination - Cisco CTS-500 Configuration Manual

Chapter 1 Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
Table 1-8 Cisco TelePresence Secure Shell Settings (continued)
Field
SSH Admin Life
SSH Helpdesk User
SSH Helpdesk Password
SSH Helpdesk Life

External CTS Log Destination

This subsection comprises six fields. The first four configure the CTS to "push" the captured logfile to
a remote server:
•
•
•
•
The second two fields configure the CTS to automatically capture logs on a periodic basis:
•
•
These two sets of fields can be configured independently of each other.
Note
OL-21851-01
Required? Setting
Yes Sets the password expiration duration to ensure that the system is protected
when using Cisco TelePresence Command Line Interface (CLI). You must
Yes
periodically update this password. See
Yes
that are used to update your password.
Yes
Password expiration can be set to have a value between 0 and 365. A setting
of 0 disables password aging. Default is 60 days. Unless the configured life
has been disabled (by being set to 0), password age is set to have 2 days
remaining in the following situations:
New installations and factory resets.
•
Software upgrades (if the password age is less than the configured age).
•
Password recovery (using the pwrecovery command).
•
An on-screen warning message is sent to the CLI user when 14 days remain
on the current password, and so on until the password expires. If the password
is allowed to expire, the system ignores the CLI login attempt and the user
cannot access the system unless a new password is created by entering
information in the
Save your changes by clicking Restart. This enables the updated
configuration to be read, applied to the CTS, and then Calling Service is
restarted
On startup, the CTS reads the Cisco Unified CM configuration and applies
any changes.
See the
Guide
Note
External CTS Log Address
Protocol
External CTS Log User Name
External CTS Log User Password
Log Period
Log Start Time
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
Secure Shell Information
.
Alternately you can click Reset, which causes the CTS to reboot.
Cisco TelePresence System Command-Line Interface Reference
for more information.
CLI Multiple Level Access (MLA)— Helpdesk user has limited
access to the CLI, no set commands are allowed.
Configuring a Cisco TelePresence Device
Figure 1-4 to see updated SSH fields
window.
1-21