Snmp Trap Receive Parameters - Cisco CTS-500 Configuration Manual

Chapter 1 Configuring Cisco Unified Communications Manager for the Cisco TelePresence System

SNMP Trap Receive Parameters

Table 1-11
Cisco TelePresence device.
Using the information in
Note
Table 1-11 Cisco TelePresence SNMP Trap Receiver Parameters
Field
SNMP Trap Receiver 1
SNMP (v3) Trap Receiver
Address
SNMP (v3) Trap Username
SNMP Security Level
SNMP (v3) Auth. Algorithm
SNMP (v3) Auth. Password
SNMP (v3) Privacy Algorithm
OL-21851-01
lists the preset SNMP trap receiver parameters that are associated with the
Table 1-11 as a guide, you can set up to five trap destinations.
Required? Setting
— IPV4 IP address or hostname of the SNMP trap receiver (the remote SNMP
system) where SNMP traps will be sent. Maximum field length is 64
characters.
— SNMP v3 only. Username used to access the system where SNMP traps are
received. Maximum field length is 32 characters. Username must begin with
a letter.
You cannot use "admin" as an SNMP trap username.
Note
Yes SNMP v3 only. Level of security supported by the SNMP Trap Receiver.
Possible field values are:
• (v3) No Authentication, No Privacy (default)
• (v3) Authentication, No Privacy
• (v3) Authentication, Privacy
• (v2c) Notification
Yes SNMP v3 only. Choose from the following authenticated algorithms:
MD5—Message-Digest algorithm 5
•
SHA—Secure Hash Algorithm
•
Yes SNMP v3 only. Password used to gain access to the SNMP server associated
with the Cisco TelePresence system. Default password is snmppassword.
Maximum field length is 32 characters.
•
Minimum field length is 8 characters.
•
Each algorithm requires different privacy and authentication
Note
passwords.
Yes SNMP v3 only. Choose from the following privacy algorithms:
• AES—Advanced Encryption Standard
• DES—Data Encryption Standard
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
Configuring a Cisco TelePresence Device
1-25