Option 56 - Communications - Honeywell Galaxy 3-48C Programming Manual

Galaxy 3 Series Programming Manual
56 - Communications
Option 56 – Communications
The Communications option is used to program the Galaxy Communication peripherals. This option has 6
sub menus, one for each of the communication peripherals. Each of these has its own set of sub menus as
detailed in the following pages.
1 = Int Telecoms (Comm 1)
This section supports programming of the on-board Telecom module, for alarm signalling and remote servicing
over PSTN.
2 = Ext RS232 (Comm 2)
This section supports programming of the RS232 module to allow direct wire communication to a serial comm
port on a PC, or over PSTN using a third party modem connection.
3 = ISDN (Comm 3)
This section supports programming of the ISDN module, for alarm signalling and remote servicing over ISDN
B and D channels.
4 = Ethernet (Comm 4)
This section supports programming of the Ethernet module for alarm signalling and remote servicing over an
Ethernet LAN/WAN using both TCP/IP and UDP/IP protocols.
5 = Ext Telecoms (Comm 5)
This section supports programming of the remote Telecom module, for alarm signalling and remote servicing
over PSTN.
6 = Int RS232 (Comm 6)
This section supports programming of the onboard RS232 port.
105