Honeywell Galaxy 3-48C Programming Manual page 155

Galaxy 3 Series Programming Manual
3. The status of the AC power and battery are displayed. Also, if available, the lowest voltage during the
last battery load test.
4. This displays the battery charging voltage and current information. The panel and Galaxy 3 Series
PSU will also display the current charging state after Battery. This is either Charging or Charged.
5. This displays the battery load test. It is only available for the on-board PSU.
Pressing the ent key again initiates a system wide battery load test. This test is only available for RIO
100 and 101.
6. This displays the AUX1 volts and current draw. Only available for Galaxy 3 series panel and on-
board PSU
7. This displays the AUX2 volts and current draw. Only available for Galaxy 3-144/3-520 series panel,
on-board PSU and SPSU.
NOTE: The current reading for the auxilliary supply is the total current of AUX1 and AUX2. The
current display on the keypad for AUX1 or AUX2 is the combined reading of both.
5. MAX COMMS - the communication level between the Galaxy panel and the MAX, MicroMAX or
MAX readers.
3
6. COMM MODULES - the communication level between the Galaxy panel and the Int Telecoms and
the Int RS232.
7. ZONES - the status of each zone can be viewed.
2 Historical
This option allows a full diagnostic baseline to be performed on the complete Galaxy system, including power
supplies and peripherals. There are 5 selectable options:
1 = View
This option allows any stored baseline data to be viewed from option 61.2.3 = Record.
1. MEMORY TEST - As latest.
2. KEYPAD COMMS - Snapshot value from last test.
3. RIO COMMS - Snapshot value from last test.
4. PSU COMMS - Snapshot value from last test.
5. MAX COMMS - Snapshot value from last test.
6. COMM MODULES - Snapshot value from last test.
7. ZONES - Snapshot value from last test. The * key allows printing of results.
61 - Diagnostics (cont'd)
149