Honeywell Galaxy 3-48C Programming Manual page 140

Galaxy 3 Series Programming Manual
56 - Communications (cont'd)
8 = Protocol
The Ethernet module is capable if signalling using either TCP (Transmission Control Protocol) or UDP (Uni-
versal Datagram Protocol). Earlier versions of Ethernet module, Alarm Monitoring and Galaxy Gold only
supported the TCP protocol.
NOTE: If communicating with V3.26 Alarm Monitoring or V6.26 Galaxy Gold the TCP option should be
selected.
If encryption is required for alarm signalling the UDP protocol should be selected.
Irrespective of the programming in this option Galaxy Gold and SIA control command protocol will always
use the TCP protocol.
0 = UDP
When this option is selected all alarm signalling from the Ethernet module will use the UDP format.
1 = TCP
When this option is selected all alarm signalling from the Ethernet module will use the TCP format.
03 = Remote Access
The Ethernet module supports remote servicing of the Galaxy alarm panel. The programming options in this
section control when remote access can be granted and whether access is initiated from the panel or the
Galaxy Gold PC.
1 = Access Period
This option determines when the Galaxy panel can be accessed remotely.
1 = Off
Galaxy Gold access to the Galaxy panel is disabled.
2 = All Unset
Remote Galaxy Gold access is only granted when all groups or the complete system are unset.
3 = Any Set
Remote Galaxy Gold access will only be granted if any of the groups or the complete system are set.
4 = Any Time (default)
Access available at any time.
2 = Mode
This option controls access authorization and whether the remote session is initiated from (Panel or PC).
1 = Direct Access
This permits access at any time (in conjunction with Access period). Access is initiated from Galaxy Gold.
Once access is authorized/initiated, uploading, downloading and remote servicing can begin.
134