Honeywell Galaxy 3-48C Programming Manual page 79

Galaxy 3 Series Programming Manual
8 = Activity Mon.
This attribute allows a zone to be checked for activity during a set time period or set/unset cycles. The options
are:
• 0 = None
• 1 = Type1
• 2 = Type2
• 3 = Type3
• 4 = Type4
• 5 = Type5
• 6 = Type6
The default option is 0 = None.
If the zone does not activate at least once within the programmed criteria a zone masked fault is indicated at
the panel. The fault is logged as a masked event which indicates that the zone has been inactive for the pro-
grammed period. See Option 51.61=Parameters.Activity Monitoring.
9 = Res. Select
This option allows the resistance windows of the zone to be set to a selection of pre-defined values. The zone
resistance windows are:
• Tamper S/C
• Normal/Closed
• High Resistance
• Alarm/Open
• Masked
• Tamper O/C
The values assigned by each of the presets are shown in tables 10 and 11, Parameter 51.46=Res. Select.
10 = Group
NOTE: The Groups attribute is only available if groups have been enabled on the system (refer to option 63
= OPTIONS).
The Group attribute allows the zone to be assigned to a single group on the system. All zones default to
Group A1.
On selecting the Group attribute, the group that the zone is currently assigned to is displayed. All zones
default to group A1. Press the number of the group that the zone is to be reassigned to and press the ent key.
Galaxy 520
The Galaxy 520 panel has 32 groups; these are displayed on the keypad in blocks of eight groups, sub-
divided into A, B, C and D:
Use the A or B key to select the required group (A1–D8). When the end of a block is reached, the next
block of eight groups is displayed; use keys 1–8 to assign the relevant group in the current block to the zone;
press the ent key to accept the selection.
52 - Program Zones (cont'd)
73