Honeywell Galaxy 3-48C Programming Manual page 105

Galaxy 3 Series Programming Manual
53 - Program Outputs (cont'd)
42 Illegal Code (Latch)
The Illegal Code is activated 60 seconds after an entry of a single Dual Code or a code which is entered
outwith the Timer A and/or Timer B times assigned to it in menu option 42.1.4=CODES.User
Codes.Time Zone.
43 Max Tamp (Latch)
The MAX TAMP output is activated when a MAX, MicroMAX or MAX tamper is activated.
3
44 Abort (Latch)
The ABORT output is activated when a valid code is entered during the Abort period on system entry.
45 Unset
The Unset output is activated each time the system (or group) is unset. The default output mode attribute is
programmed as pulse, for two seconds. This can be used to activate a buzzer to notify a user that the system
has been unset, when using an RF fob.
46 Set Late (Latch)
The Set Late output is activated if the system has not been set by the programmed Monitor time – refer to
option 65.3.1=TIMERS.Autoset.Status.
47 U/S Early (Latch)
The Unset Early output is activated if the system has been unset before the programmed Monitor time –
refer to option 65.3.1=TIMERS.Autoset.Status.
48 Prewarn (Reflex)
The Prewarn output is active during the programmed prewarning period of the autoset function. The mode is
Reflex. The Prewarn emits a constant tone if the autosetting of the system can be extended. If an extension
is not possible, the Prewarn output pulses.
49 Autoset (Reflex)
The Autoset output is activated when the system has been set by the autoset function – refer to option
65.3=TIMERS.Autoset. The default Output Mode attribute is programmed as Reflex, therefore the output
remains active until the system unsets.
NOTE: The Set is also activated when the system autosets.
50 DR. Masked
The DR. (detector) Masked output is activated when zones, programmed for zone activity checks, are not
activated in the unset state within the time period or set/unset cycles programmed in Parameter 51.61. The
zones are programmed for activity in menu 52.8.
51 – 65 Link A – O (Reflex)
Link output types have no inherent function: they are designed for use with option 54 = LINKS to provide the
engineer with a means of activating a specific output address.
99