Honeywell Galaxy 3-48C Programming Manual page 118

56 - Communications (cont'd)
Account Groups
It is possible to have a number of groups bound by the same Account Number (an Account Group).This
means that one CL signal is not sent until all the groups within the Account Group are set. Individual groups
within the Account Group will not send a CL signal. The groups within the Account Group are identified by
a starred ( ) Account Number, for example, 2112.
When the Account Group is fully set, the identifier of the CL message is 999 to identify it as an Account
Group that has set.
For unset, each group that is part of the Account Group can report individually that it is open.
NOTE: Account Groups only operate for SIA signalling.
3 = Microtech
Microtech format is a protocol that transmits detailed point identification information to a Personal Computer
(PC) which has the Galaxy Alarm Monitoring software installed.
The menu structure and programming of the options are identical to the SIA format. Refer to 2 = SIA for
programming details.
4 = Contact ID
Contact ID format is a protocol which transmits point identification information to an Alarm Receiving Centre
that is capable of receiving the Galaxy variant of contact ID.
The menu structure and programming of the options are identical to the SIA format with the exception of the
2 = Ack timeout programming option. This option can be set to 1 (30 seconds) or 2 (60 seconds). Refer to
2 = SIA for programming details.
02 Telephone No. 1
Telephone number 1 must be entered. This is the main telephone number that the alarms are signalled to. Up
to 22 digits may be entered, including control modifiers. The control modifiers are entered using the
keys:
Pause (for two seconds before dialling the next digit). Multiple entries can be made, for example,
entering gives a six second pause.
# Dial tone detect (wait for new dial tone). Each dial tone detect lasts for 15 seconds. Multiple entries can
be made, for example, entering ## gives a 30 second dial tone detect. If a new dial tone is not detected in this
time, then the dialling attempt is aborted. This is counted as a fail to communicate.
The B key is used to erase an existing telephone number. Each press deletes the last digit displayed.
03 Account No.
This is the site identifier. A unique account number must be entered, this can be up to a maximum of six digits
although four digits is the standard.
The B key is used to erase an existing number. Each press deletes the last digit displayed.
NOTE: Entering the account number into this menu option automatically copies the number to all channel or
group triggers in the selected format. Any individual account numbers that have been programmed
are overwritten.
Galaxy 3 Series Programming Manual
112
and #