Honeywell Galaxy 3-48C Programming Manual page 208

Event Log (cont'd)
KEYPAD TEXT
RM ACCESS Remote Access zone activated
+ SEC FINAL Security Final zone activated (opened)
- SEC FINAL Security Final zone closed (closed)
+ SECURITY Security zone activated (opened).
– SECURITY Security zone de-activated (closed).
SET LOG Set Log zone activated (opened) when the system or group(s) is set.
SOAK TEST Zone under Soak Test (Menu Option 55) activated when the system or group(s) is Set.
SPARE Spare zone opened.
STANDLOW Standby time for the battery is Low.
SUSP. SET Setting of system suspended
SYS RESET System Reset has occurred event.
+ TAMP C/V constant Voltage tamper event
+ TAMP O/C Zone changing to Tamper Open Circuit (greater than 12,000 Ohm).
– TAMP O/C Zone changing from Tamper Open Circuit to Normal Closed (1200 to 900 Ohm).
TAMP RST Tamper Reset of the system has occurred.
+ TAMP S/C Zone changing to Tamper Short Circuit (less than 800 Ohm).
– TAMP S/C Zone changing from Tamper Short Circuit (less than 800 Ohm). to Normal Closed (900 to 1200 Ohm).
Tamper on a module activated (opened). A module is either a keypad, Galaxy RIO, Telecom Module
+ TAMPER
or RS232 Module.
Tamper on a module de-activated (closed). A module is either a keypad, Galaxy RIO, Telecom
– TAMPER
Module or RS232 Module.
TEST O/P Test Outputs menu (Menu Option 32) has been accessed.
TIMEOUT Timeout alarm after the Entry Time has expired.
TIMER A + Timer A activated (on).
TIMER A – Timer A de-activated (off).
TIMER B + Timer B activated (on).
TIMER B – Timer B de-activated (off).
T/O-BURGL Timeout alarm after the Entry Time has expired (same as TIMEOUT but used as a SIA event).
U/S EARLY The Unset Early output has been activated before programmed time.
UNSET Unset of the system or Group(s).
URGENT Urgent zone activated.
VIBRATION Vibration zone activated.
VIDEO Video zone activated (opened).
VID EXIT Video Exit zone activated (opened).
WALK TEST + Walk Test has occurred.
WALK TEST – Walk Test has finished.
WALL TAMP Wall Tamper zone alarm.
WRONG CD Wrong Code alarm activation (6 consecutive wrong codes). This Requires a system reset.
24 HOURS 24 Hours zone activated (opened).
NOTE: M = Mandatory. NM = Non-Mandatory
NOTE: A plus (+) means an event has started. A negative (-) means an event has finished.
Galaxy 3 Series Programming Manual
DESCRIPTION
D-6
Trigger Event
14. Menu Access NM
4. Security M
4. Security
M
18. Zone restoral
4. Security M
4. Security
M
18. Zone restoral
16. Log zone M
None NM
16. Log zone M
13. Elec status M
None NM
11. Reset/Cancel NM
9. Tamper M
9. Tamper M
9. Tamper
M
18. Zone restoral
9. Tamper NM
9. Tamper M
9. Tamper
M
18. Zone restoral
9. Tamper M
9. Tamper
M
18. Zone restoral
None NM
10. Setting M
None NM
None NM
None NM
None NM
2. Intruder M
10. Setting NM
10. Setting M
3. 24 Hours M
2. Intruder
NM
16. Log Zone
2. Intruder M
2. Intruder M
14. Menu access NM
14. Menu access NM
9. Tamper M
9. Tamper M
3. 24 Hours M