Honeywell Galaxy 3-48C Programming Manual page 152

58 - Keypad (cont'd)
6 = Show Status
This option allows the keypad to display the set status of the groups. When Show Status is enabled, pressing
the and # keys simultaneously when the normal banner is displayed indicates the group set status.
F = Fault
R = Ready
S = Set
P = Part Set
L = Locked Out
- = Group not assigned to Keypad
NOTE: The Show Status indicates the set conditions of groups when the system is set (keypad blank) or
unset (normal banner). Show Status does not operate while engineer mode is accessed.
Pressing the and # keys again toggles the display to show the status of the groups individually. To move
between each groups, press the
Pressing the and # keys again returns the keypad to the banner display.
Galaxy 520
The Galaxy 520 has 32 groups; these are displayed on the keypad in block of eight groups, sub-divided into
A, B, C and D. Press the A or B key to display each of the group blocks.
7 = Keypad Groups
Each keypad can be assigned to selected groups; the keypad then responds only to user codes that have a
group common to it and only displays alarm information on the groups assigned.
Entering a user code which is assigned to all groups, on a keypad which is only assigned to a single group,
allows access to all of the user's groups. The user is not restricted by the groups that are assigned to the
keypad as long as there is one group common to both. This means that a keypad assigned only to group 1, for
example, can be used to set groups 1, 2, 3 and 4 by a code with all of these groups allocated.
Keypad Group Restriction
To restrict access only to groups that are common to both the user and the keypad, press the
assigning groups to the keypad. This means that when a user with access to groups 1, 2 and 3 sets the system
on a keypad assigned to groups 2, 3 and 4, only the common groups (groups 2 and 3) are set.
Assigning Keypad Groups
On selecting the Keypad Groups option, the groups currently allocated to the keypad are displayed (the default
is all groups assigned). Pressing the group number toggles the group assigned to the keypad.
Galaxy 520
The Galaxy 520 has 32 groups; these are displayed on the keypad in block of eight groups, sub-divided into A, B,
C and D. Use the A or B key to move between the group blocks; press keys 1 – 8 to assign the relevant groups
in each block to the user.
When the required groups have been assigned to the user, press the ent key to accept the programming and
return to the previous menu level.
NOTE: Also see menu 53, to control the buzzer operation on each keypad. This is independent of the
keypad group parameter.
Galaxy 3 Series Programming Manual
STATUS 12345678 STATUS 12345678 STATUS 12345678 STATUS 12345678 STATUS 12345678
Groups RRSRLPFP Groups RRSRLPFP Groups RRSRLPFP
Groups RRSRLPFP Groups RRSRLPFP
and A or the and B keys simultaneously.
146
Group block
key when