Honeywell Galaxy 3-48C Programming Manual page 125

Galaxy 3 Series Programming Manual
2 Format
This option allows selection of the alarm signalling format. There are two formats available for the RS232
module:
1 = SIA
Refer to the Telecom format menu (56.1.2) for programming details.
2 = Microtech
Refer to the Telecom format menu (56.1.3) for programming details.
NOTE: The SIA and Microtech formats for the RS232 module are identical in structure and programming to
the Telecom menu. The only difference is that when groups have been enabled there is no Group
Settings option.
3 Account No.
This is the site identifier. A unique account number must be entered, this can be up to a maximum of six digits.
The B key is used to erase an existing number. Each press deletes the last digit displayed.
4 Copy/Overwrite
1 = Copy Site
The Copy Site option copies the programming details stored on the Galaxy panel to the Ext. RS232 module.
On selecting this option the keypad indicates if a panel program is already stored in the module memory. To
copy the panel programming press 1; the message COPYING is displayed; the green COPY LED (LED3)
on the Ext. RS232 module flashes. When the entire program has been copied to the module, the message
COPY STORED appears; the green COPY LED (LED3) remains on.
NOTE: The copying procedure can be aborted at any time by pressing key 2.
2 = Overwrite Site
The Overwrite Site option copies the program stored on the Ext. RS232 module to the Galaxy panel,
overwriting all current programming details. On selecting this option the keypad indicates that the Galaxy is
WAITING TO WRITE. To overwrite the panel programming press 1; the message OVERWRITING is
displayed; the green OVERWRITE LED (LED4) on the Ext. RS232 module flashes. When the entire
program has been copied to the Galaxy panel, the message OVERWRITE DONE appears; the green
OVERWRITE LED (LED4) remains on.
NOTE: The overwriting procedure can be aborted at any time by pressing key 2.
3 = Copy Stored
If the Ext. RS232 has programming details stored in its memory, the Copy Stored option indicates: the date;
the panel type; and the version of software that was copied.
If there is no program in the Ext. RS232 module memory, the message NO COPY STORED is displayed.
56 - Communications (cont'd)
119