Advertisement
1.
Description (TASK 33-30-15-99C-811-A01)
A.
General (Subtask 33-30-15-99C-021-A01)
(1)
This section gives the parts that are used to make the door mounted cargo loading light. It also
supplies the necessary data to get replacement parts for REPAIR (PGBLK 33-30-15-6000) and
TESTING AND FAULT ISOLATION (PGBLK 33-30-15-1000).
(2)
The DPL part of the ILLUSTRATED PARTS LIST (IPL 33-30-15-10000) gives a breakdown, in
disassembly sequence, of assemblies and detail parts of the unit.
(3)
The illustrations show where you can find each part and are an important aid in DISASSEMBLY
(PGBLK 33-30-15-3000) and ASSEMBLY (PGBLK 33-30-15-7000).
(4)
The item numbers shown in the DPL are the same as the item numbers on the exploded view
illustration(s). To find a part number, find the part on the illustration and record the item number.
Go to the DPL to find the item number and related part number.
B.
Job Setup Data (Subtask 33-30-15-99C-022-A01)
(1)
The list that follows identifies references that are related to this section:
• CAGE codes and manufacturers' addresses are available at https://cage.dla.mil.
2.
Contents of the IPL (TASK 33-30-15-99C-812-A01)
A.
Vendor Code List (Subtask 33-30-15-99C-023-A01)
(1)
The vendor code list shows the vendor CAGE code, name, and address in numerical sequence
for all vendors shown in the IPL. Refer to the Vendor Code List.
(2)
The vendor CAGE code is given in the nomenclature column of the DPL to identify the vendor.
B.
Equipment Designator Index (Subtask 33-30-15-99C-024-A01)
(1)
The EDI is an alphanumeric list of the equipment designators given to the subassemblies and
electrical/electronic parts. The designators are an aid to identify parts in SCHEMATIC AND
WIRING DIAGRAMS (PGBLK 33-30-15-2000). Refer to the Equipment Designation Index List.
(2)
Each entry in the EDI identifies the figure and item numbers where the part is found in the
DPL. The EDI can also identify a geographical location of the equipment designator found on
the graphic illustration. If the Equipment Designator Index table lists U17 as located in the
4E area, go to the illustration and find 4 on the left grid and E on the top grid and follow it to
where it intersects. You should find the component within that grid location on the illustration. A
hyphen between two designators shows a continuous sequence of designators (example:
A1-A5 is the same as A1 thru A5).
NOTE:
C.
Numerical Index (Subtask 33-30-15-99C-025-A01)
(1)
The NI is an alphanumeric list of all the part numbers shown in the part number column of
the DPL.
(2)
Also included in the index are the Honeywell part numbers that are equivalent to the
manufacturer part number. Optional manufacturer part numbers are not included in the index.
(3)
The figure item column gives all of the locations of a part. If a part number is in more than one
figure item location, the part number is shown only one time in the part number column.
EFFECTIVITY
ALL
© Honeywell International Inc. Do not copy without express permission of Honeywell.
COMPONENT MAINTENANCE MANUAL
15-0705
ILLUSTRATED PARTS LIST
If the component is not shown on the illustration, it may be hidden under a raised
component. Thus, it will not be viewable on the illustration.
33-30-15
Page 10001
30 Mar 2017
Advertisement
