Advertisement
1.
How to Use This Manual (TASK 33-30-15-99F-801-A01)
A.
General (Subtask 33-30-15-99F-001-A01)
(1)
This publication gives maintenance instructions for the equipment shown on the Title page.
(2)
Standard maintenance procedures that technicians must know are not given in this manual.
(3)
This publication is written in agreement with the ATA Specification.
(4)
Refer to the Special Tools, Fixtures, and Equipment and Consumables tables in each section
before the start of maintenance or repair procedures.
(5)
An explanation on how to use the ILLUSTRATED PARTS LIST (IPL 33-30-15-10000) is given
in the Introduction to that section.
(6)
Honeywell recommends that you do the tests in TESTING AND FAULT ISOLATION (PGBLK
33-30-15-1000) before you disassemble the unit. These tests can show the condition of the
unit or most possible cause of a malfunction. If a malfunction occurs, repair as necessary.
(7)
Warnings, cautions, and notes in this manual give the data that follows:
• A WARNING gives a condition or tells personnel what part of an operation or maintenance
procedure, which if not obeyed, can cause injury or death
• A CAUTION gives a condition or tells personnel what part of an operation or maintenance
procedure, which if not obeyed, can cause damage to the equipment
• A NOTE gives data, not commands. The NOTE helps personnel when they do the related
instruction.
(8)
Warnings and cautions go before the applicable paragraph or step. Notes follow the applicable
paragraph or step.
B.
Observance of Manual Instructions (Subtask 33-30-15-99F-002-A01)
(1)
Make sure that you carefully obey all safety, quality, operation, and shop procedures for the unit.
(2)
All personnel who operate equipment and do maintenance specified in this manual must know
and obey the safety precautions.
C.
Symbols (Subtask 33-30-15-99F-003-A01)
(1)
The symbols and special characters are in agreement with IEEE Publication 260 and IEC
Publication 27. Special characters in text are spelled out.
(2)
The signal mnemonics, unit control designators, and test designators are shown in capital
letters.
(3)
The signal names followed by an "*" show an active low signal.
(4)
Some figures in this manual incorporate standard geometric characteristic symbols. Refer to
Figure INTRO-1 for the geometric characteristic symbols.
EFFECTIVITY
ALL
© Honeywell International Inc. Do not copy without express permission of Honeywell.
COMPONENT MAINTENANCE MANUAL
15-0705
INTRODUCTION
33-30-15
Page INTRO-1
30 Mar 2017
Advertisement
