Advertisement
D.
Metal Mechanical Parts (Subtask 33-30-15-100-004-A01)
CAUTION:
WHEN YOU REMOVE CORROSION, MOVE THE ABRASIVE CLOTH PARALLEL TO
THE AXIS OF THE PART. IF YOU MOVE THE ABRASIVE CLOTH ACROSS THE
AXIS, YOU CAN CAUSE DAMAGE TO THE FINISH.
CAUTION:
DO NOT USE CROCUS CLOTH ON ALUMINUM PARTS. CLOTH CONTAINS IRON
OXIDE, WHICH CAUSES RAPID OXIDATION OF ALUMINUM.
CAUTION:
DO NOT CHANGE THE SURFACE FINISH OR THE SHAPE OF THE PART. DO
NOT REPAIR THE PART MORE THAN THE WEAR LIMITS. FAILURE TO OBEY
CAN CAUSE FAILURE OF THE PART.
(1)
Remove a thin layer of surface corrosion with correct abrasive cloth. Use ANSI B74.18
aluminum oxide abrasive cloth on aluminum parts. Use P-C-458 crocus cloth on metal parts.
(2)
Clean the metal parts in Armakleen M-HP II aqueous cleaner. Use a soft-bristle brush to
remove ground-in deposits.
WARNING:
AIR PRESSURE MUST BE LIMITED TO 30 POUNDS PER SQUARE INCH (207
KILOPASCAL).
(3)
Dry the part with compressed air or clean with an A-A-59323 cleaning cloth and dry the
parts in the air.
E.
Job Close-up (Subtask 33-30-15-100-005-A01)
(1)
Remove all tools, equipment, and unwanted materials from the work area.
EFFECTIVITY
ALL
© Honeywell International Inc. Do not copy without express permission of Honeywell.
COMPONENT MAINTENANCE MANUAL
15-0705
33-30-15
Page 4003
30 Mar 2017
Advertisement
