Cli Commands For Troubleshooting - Cisco SCE 1000 Installation And Configuration Manual

Chapter 8 Troubleshooting

CLI Commands for Troubleshooting

Use the following commands to provide information to help you troubleshoot installation of your
SCE 1000 platform. Refer to
SCE 2000 and SCE 1000 CLI Command Reference
Remember that if the management interface is not operational, you should connect the SCE 1000
platform to a local console so that you can enter CLI commands for troubleshooting.
•
•
OL-26790-01
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Troubleshooting firmware package installation:
boot system <filename>— Specifies and verifies the package file to be installed. Error messages
–
or other output identify problems with the package file.
Following is a sample output from the Boot system command.
SCE 1000(config)#boot system ftp://vk:vk@10.1.1.230/downloads/SENum.pkg.pkgVerifying
package file SENum.pkg.pkg...
Package file verified OK.
Troubleshooting the management subsystem:
show interface Mng — Displays IP address and auto-negotiation information for the
–
management interfaces.
Following is a sample output from the show interface Mng command.
ip address: 10.1.6.145
subnet mask: 255.255.0.0
Configured speed: auto, configured duplex: auto
AutoNegotiation is On, link is Up, actual speed: 100, actual duplex: half
– show ip default-gateway — Displays the IP address of the configured default gateway.
Following is a sample output from the show ip default-gateway command.
Default gateway: 10.1.1.1
– show ip route — Displays the entire routing table and the destination of last resort
(default-gateway).
Following is a sample output from the show ip route command.
gateway of last resort is 10.1.1.1
– show access-lists—Shows all access-lists or a specific access list.
Following is a sample output from the show access-lists command.
Standard IP access list 1
Permit 10.1.1.0, wildcard bits 0.0.0.255
deny any
show telnet—Displays the status of the telnet server daemon (status) or any active Telnet
–
sessions (sessions).
Following is a sample output from the show telnet command.
show telnet sessions There is 1 active telnet session:
Index | Source
================
0 | 10.1.1.201show telnet status Telnet deamon is enabled.
show line vty timeout— Shows the timeout configured for Telnet sessions.
–
Information About Troubleshooting Tools
for more information.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
or the Cisco
8-3