How To Cable The External Optical Bypass Module - Cisco SCE 1000 Installation And Configuration Manual

Appendix A External Optical Bypass Module
Note that, although each module is shipped with its own mounting panel, it is not necessary to install
each module in a separate mounting panel. Up to three modules may be installed in one mounting panel.
Using the screws attached to the module, screw it into an empty position in the mounting panel.
Step 1
Secure the module panel to the two front posts of the rack above the SCE 1000 platform. Leave at least
Step 2
1.5 cm vertical clearance between the SCE 1000 platform and the module panel to provide space for the
cables from the front panel of the module to the rear of the SCE 1000 platform.

How to Cable the External Optical Bypass Module

The following procedure describes how to cable the External Optical Bypass module
the following:
•
•
•
Figure A-4
Figure A-5
OL-26790-01
All connections to the External Optical Bypass module are on the front panel of the module.
If installing only one module, the connections are as follows:
Connect the fiber (steps 3 and 4) to the GBE-1 Line ports on the SCE 1000 platform.
–
Connect the control cable to the Bypass 1 9-pin D-Type connector on the rear panel of the
–
SCE 1000 platform.
If installing two modules, repeat the entire procedure for the second module, with the following
changes:
Connect the fiber (steps 3 and 4) to the GBE-2 Line/Cascade ports on the SCE 1000 platform.
–
Connect the control cable to the Bypass 2 9-pin D-Type connector on the rear panel of the
–
SCE 1000 platform.
Bypass Connector on the Rear Panel of the SCE 1000 Platform
1
BY PA SS
1
IN
PO W ER B
OK
IN
PO W ER A
illustrates the connectors on the External Optical Bypass module.
OK
Cisco SCE 1000 2xGBE Installation and Configuration Guide
How to Cable the External Optical Bypass Module
(Figure A-4). Note
A-5