Reconnecting The Power; How To Reconnect Ac-Input Power Supply Unit - Cisco SCE 1000 Installation And Configuration Manual

Chapter 4 Installation and Maintenance

Reconnecting the Power

The following sections describe how to reconnect the AC or DC power:
•
•

How to Reconnect AC-Input Power Supply Unit

The following procedures explain how to reconnect an AC-input power to the SCE 1000 platform.
If you are reconnecting DC-input power, proceed to
page
Step 1 Plug the AC-input power cable into the AC-input power receptacle on the AC-input power supply
(Figure
Figure 4-16
For AC-input power, we recommend powering the SCE 1000 platform from a 120 VAC, 15A receptacle
Note
U.S. (240 VAC, 10A international) at the power source.
15 A branch circuit protection is recommended.
Note
Plug the AC power supply cable into the AC power source.
Step 2
Turn the on/off switch to the on position.
Step 3
Look at the IN and OK LEDs on the power supply unit and the corresponding Power LED on the front
Step 4
panel. If the new AC-input power supply unit is operating properly, these LEDs will be glowing green.
Ensure that the power supply is properly aligned and the installation screw is tightened.
Step 5
OL-26790-01
How to Reconnect AC-Input Power Supply Unit, page 4-21
How to Reconnect DC-Input Power Supply Unit, page 4-22
4-22.
4-16).
Connecting the AC Power
BY PA SS
1
IN
PO W ER B
OK
IN
PO W ER A
How to Reconnect DC-Input Power Supply Unit,
OK
Cisco SCE 1000 2xGBE Installation and Configuration Guide

Reconnecting the Power

4-21