How To Install The Sce 1000 On A Workbench Or Tabletop; What To Do Next - Cisco SCE 1000 Installation And Configuration Manual

How to Install the SCE 1000 on a Workbench or Tabletop

How to Install the SCE 1000 on a Workbench or Tabletop
You can install the SCE 1000 platform on any flat surface as long as the surface is large enough for the
SCE 1000, and allows for adequate airflow/ventilation around the sides of the SCE 1000, as described
in the Installation Precautions. When installing the SCE 1000 on a workbench or tabletop or in a rack,
ensure that the surface is clean and in a safe location.
Figure 4-3
1
Remove any debris and dust from the tabletop or workbench, as well as the surrounding area. Also make
Step 1
sure your path between the SCE 1000 platform and its new location is unobstructed.
Place the SCE 1000 platform on the tabletop or workbench.
Step 2
View the bottom panel by lifting the SCE 1000, placing your hands around the SCE 1000 sides and lifting
Step 3
the SCE 1000 from underneath. To prevent injury, avoid sudden twists or moves.
There are four marked locations, indicating where to affix the rubber feet (see
Attach the rubber feet by removing the adhesive strips and affix the rubber feet onto the marked locations
Step 4
(on the bottom panel).
Replace the SCE 1000 platform firmly on the tabletop or workbench.
Step 5
Remember to check for proper ventilation. Allow at least 2 inches (5 cm) on each side for proper
ventilation and 5 inches (12.7 cm) at the back for ventilation and power cord clearance.

What to Do Next

Proceed to section,
Cisco SCE 1000 2xGBE Installation and Configuration Guide
4-6
Installing the System on a Flat Surface
C is co S
TX
LINK RX
BYP ASS
STA TUS TX
LINK RX
PW R B
PW R A
TX
MM
RX
TX
MM
RX
GBE -1
NET
LINE
AU X
SUB
LE
CO NSO
MN G 2
MN G 1
LINK / 10/1 00/
10/1 00/ 1000
LINK / ACT IVE
1000
ACT IVE
2
How to Attach a Chassis Ground Connection
Se rie s
C E 10 00
2x G B E
Chapter 4 Installation and Maintenance
Figure 4-3).
to continue the installation.
OL-26790-01