Organization - Cisco SCE 1000 Installation And Configuration Manual

About this Guide

Organization

This guide contains the following sections:
Table 2
Section
1
2
3
4
5
6
7
8
A
OL-26790-01
Document Organization
Title
Chapter 1, "General Overview"
Chapter 2, "Introduction to the SCE
Platform"
Chapter 3, "Information About
Topology"
Chapter 4, "Installation and
Maintenance"
Chapter 5, "Connecting the
Management Interfaces and
Performing Initial System
Configuration"
Chapter 6, "Cabling the Line Ports
and Completing the Installation"
Chapter 7, "Basic SCE 1000 Platform
Operations"
Chapter 8, "Troubleshooting"
Appendix A, "External Optical
Bypass Module"
Description
This chapter provides a brief introduction to Cisco
Service Control.
This chapter provides a hardware overview of the
SCE 1000 platform.
This chapter describes the possible deployment
topologies of the SCE 1000 and explains how
various aspects of the topology determine the
configuration of the system.
This chapter explains how to install an SCE 1000
platform in a rack or in a general tabletop
installation and how to install or replace the power
supply units and fan modules.
This chapter explains how to connect the SCE
1000 platform to a local console and perform the
initial system configuration via the setup wizard
that runs automatically.
This chapter provides instructions for cabling the
Gigabit Ethernet ports and for configuring Gigabit
Ethernet (GBE) interface parameters.
This chapter describes how to start up the SCE
1000 platform, reboot, and shutdown. It also
describes how to manage configurations.
This chapter provides basic system startup
troubleshooting information.
This appendix explains how to install the optional
external optical bypass module.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
xi