How To Replace The Fan Module - Cisco SCE 1000 Installation And Configuration Manual

Chapter 4 Installation and Maintenance

How to Replace the Fan Module

Grasp the fan module handle with one hand and place your other hand underneath the fan module for
Step 1
support. The handle of the unit should be at the bottom.
Fit the groove in the side of the new fan module into the guide in the chassis.
Step 2
Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear panel
Step 3
(Figure
Figure 4-19
When inserting a fan module into the SCE 1000 platform, do not use unnecessary force; slamming the
fan module into the chassis can damage the connectors on the rear of the module.
Seat the fan module in the SCE 1000 platform by tightening the two captive installation screws with a
Step 4
1/4-inch flat-blade screwdriver.
The fan module is not fully seated until you tighten the installation screws on the faceplate.
Note
OL-26790-01
4-19).
Inserting the Fan Module
BY PA SS
1
IN
PO W ER B
OK
IN
PO W ER A
OK
Removing and Replacing the Fan Module
Cisco SCE 1000 2xGBE Installation and Configuration Guide
4-25