Connecting The Line Ports To The Network; Cabling Diagrams; Single Link: Inline Topology - Cisco SCE 1000 Installation And Configuration Manual

Connecting the Line Ports to the Network

Connecting the Line Ports to the Network
This module explains the procedures for cabling the line ports, configuring the interface parameters, and
testing connectivity of the links.
•
•
•
•
•

Cabling Diagrams

Before beginning, find the appropriate cabling diagram for the topology in your installation:
•
•

Single Link: Inline Topology

In the inline topology
between the subscribers, which are usually connected through either a BRAS (in DSL access), a PDSN
(in wireless access), a CMTS (in the Cable access), or a switch or router aggregator (in other topologies),
and the network, where the SCE 1000 usually connects to a router or layer 3 switch network element.
Figure 6-1
Cisco SCE 1000 2xGBE Installation and Configuration Guide
6-2
Cabling Diagrams, page 6-2
How to Configure Gigabit Ethernet Auto-Negotiation, page 6-4
Connecting the GBE Line Interface Ports, page 6-4
Testing Connectivity: Examining Link LEDs and Counters, page 6-6
What to Do Next, page 6-7
Single Link: Inline Topology, page 6-2
Single Link: Receive-only Topology, page 6-3
(Figure 6-1), the SCE 1000 resides physically on the GBE (Gigabit Ethernet) link
Single Link: Inline Topology
PWR A PWR B STATUS BYPASS
Subscriber
Router/Switch
Subscriber
Chapter 6 Cabling the Line Ports and Completing the Installation
LINK RX TX LINK RX TX
RX MM TX RX MM TX
GBE-1
SUB LINE NET
Network
Cisco SCE 1000
Series
2xGBE
Network
Router/Switch
OL-26790-01