Example - Cisco SCE 1000 Installation And Configuration Manual

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Enter the SNTP configuration menu.
Step 5
If you do not wish to configure the SNTP, skip the rest of this section and go to
DNS Settings, page
To enter the SNTP configuration dialog, type y, and press Enter
Would you like to enter the SNTP configuration menu? [no]: y
Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
Step 6
•
•
Define the time interval between unicast updates.
Step 7
•
Specify an IP address for the SNTP unicast server.
Step 8
Type in the hostname or the IP address in the form x.x.x.x, and press Enter
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1

Example

Following is a sample time setting dialog. In addition to setting the time zone, time and date are changed,
and SNTP unicast updates are configured.
Would you like to enter the Time settings menu? [no]: y
Enter time zone name [UTC]: ISR
Enter time zone minutes offset from UTC: 120
The local time and date is 15:35:23 ISR FRI July 19 2002
Would you like to set a new time and date? [no]: y
This change will take effect immediately both on the system clock
and the calendar; it will also set the time zone you entered.
Are you sure? [yes/no]: y
Enter new local time and date: 14:35:23 19 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
Would you like to enter the SNTP configuration menu? [no]: y
Enable SNTP broadcast client? [no]: y
Enter time interval in seconds between unicast updates [900]:
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1
OL-26790-01
5-12.
To disable the SNTP broadcast client, press Enter.
To enable the SNTP broadcast client, type y and press Enter.
Enable SNTP broadcast client? [no]:
To accept the displayed default value, press Enter.
Enter time interval in seconds between unicast updates [1024]:
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Step 4: Configuring Time Settings
Step 5: Configuring the
5-11