What To Do Next - Cisco SCE 1000 Installation And Configuration Manual

Chapter 6 Cabling the Line Ports and Completing the Installation
The following example displays a system response.
EXAMPLE:
SCE 1000numbershow interface Gigabit Ethernet 0/1Auto negotiation configured: Enabled
Actual Status:
Link is on, Auto negotiation: Enabled,
Bandwidth: 100000Kbps,
Burst-size: 50000bytes
Again, auto-negotiation for bump-in-the-wire topology may be enabled or disabled. For receive-only
topologies, using an external splitter, auto-negotiation must be disabled.
How to View the Gigabit Ethernet Counters
Step 1 Type show interface GigabitEthernet 0/interface counters.
This displays the Gigabit Ethernet counters. This command enables you to verify that traffic is taking
place. You can see that the counters increase, together with the increased number of packets that flow
through the SCE 1000.
Again, in bump-in-the-wire topology, both the Rx and Tx counters are relevant as traffic monitors. For
receive-only topologies, using an external switch, only the Rx counters are relevant.
The following example shows the counters of the first Gigabit Ethernet interface:
SCE 1000numbershow interface GigabitEthernet 0/1 countersIn total octets: 100
In good unicast packets: 90
In good multicast packets: 0
In good broadcast packets: 10
In packets discarded: 0
In packets with CRC/Alignment error: 0
In undersized packets: 0
In oversized packets: 0
Out total octets: 93*2^32+1022342538
Out unicast packets: 858086051
Out non unicast packets: 0
Out packets discarded: 0

What to Do Next

You are now ready to continue to the next stage,
Application, page
OL-26790-01
6-8.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
How to Load and Activate a Service Control
What to Do Next
6-7