How To Attach The Cross Rail Supports To The Rack - Cisco SCE 1000 Installation And Configuration Manual

2xgbe
Hide thumbs Also See for SCE 1000:
Table of Contents

Advertisement

Chapter 4 Installation and Maintenance
Repeat steps 1 and 2 on the other side of the SCE 1000.
Step 3
This completes the steps for attaching the rack-mount brackets to the SCE 1000.
If mounting the SCE 1000 in a rack with only two posts, skip to How to Mount the System to the Rack.
If mounting the SCE 1000 in a rack with four posts, proceed to the next step to attach the cross rail
supports to the rack.

How to Attach the Cross Rail Supports to the Rack

When mounting in a rack with four posts (front and back) the two cross rail supports are mounted one
on each side of the rack. The SCE 1000 then slides into these cross rails, which support the weight of
the unit.
Note
Cisco recommends that you allow at least 1 or 2 inches (2.54 or 5.08 cm) of vertical clearance between
the SCE 1000 and any equipment directly above and below it.
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Assemble the two cross rail supports as shown in
Step 1
assembly.
Make sure that they are oriented so that both cross rails will support the SCE 1000 when they are attached
to the rack.
Figure 4-8
Step 2
Align the cross rail supports with the side of the rack, parallel to the floor.
Step 3
Insert and tighten two screws to the front posts or mounting strips of the rack
OL-26790-01
Assemble the two cross rail supports as illustrated below. Use three screws for each cross rail
assembly.
Align the cross rail supports with the side of the rack, parallel to the floor.
Insert and tighten two screws to the front posts or mounting strips of the rack
Insert and tighten two screws to the Back posts of the rack.
Repeat steps 2 through 4 on the other side of the rack, keeping the brackets flush against the posts
and parallel to the supporting bracket on first side of the rack.
Assembling the Slider Brackets
1
2
Figure
4-8. Use three screws for each cross rail
3
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Rack-Mounting a SCE 1000 Platform
4-9

Advertisement

Table of Contents
loading

Table of Contents