Example; Step 9: Configuring The Topology-Dependent Parameters; About The Topology-Dependent Parameters - Cisco SCE 1000 Installation And Configuration Manual

Step 9: Configuring the Topology-Dependent Parameters

Configure the Authentication Failure trap status.
Step 9
•
•
Configure the SCE enterprise trap status.
Step 10
•
•
Specify the system administrator.
Step 11
Type the name of the system administrator and press Enter.
Note that there is no default for this parameter.
Enter system administrator contact name []:

Example

Following is a sample SNMP configuration, configuring one trap manager, one GET community, and
one SET community, and enabling the authentication failure trap, as well as all enterprise traps.
Would you like to enter the SNMP configuration menu? [no]: y
Enable SNMP management? [no]: y
Enter SNMP GET community name[]: public
Enter Access list number allowing access with this community string, use '0' to allow all:
0
Would you like to add another SNMP GET community? [no]:
Enter SNMP SET community name[]: private
Enter Access list number allowing access with this community string, use '0' to allow all:
2
Would you like to add another SNMP SET community? [no]:
Would you like to configure SNMP trap managers? [no]: y
Enter SNMP trap manager IP address: 10.1.1.253
Enter SNMP trap manager community string: public
Enter trap manager SNMP version: 2c
Would you like to add another SNMP trap manager? [no]:
Enable the 'Authentication Failure' trap [no]: y
Enable SCE enterprise traps []: y
Enter system administrator contact name []: John Smith

Step 9: Configuring the Topology-Dependent Parameters

•
•

About the Topology-Dependent Parameters

The topology configuration menu is a series of guided questions relating to the deployment of the
SCE 1000 in the network and its mode of operation. Values for the parameters are configured based on
the user answers.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-20
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
To disable the Authentication Failure trap, press Enter.
To enable the Authentication Failure trap, type y and press Enter.
Enable the 'Authentication Failure' trap [no]:
To disable the SCE enterprise traps, type n press Enter.
To enable the SCE enterprise traps, type y and press Enter.
Enable the SCE enterprise traps []:
About the Topology-Dependent Parameters
Examples
OL-26790-01