Cisco SCE 1000 Installation And Configuration Manual page 25

Chapter 2 Introduction to the SCE Platform
Table 2-2
Port
Mng1/ Mng2
Console
AUX
GBE ports 1-2
Table 2-3
LED Groups
Power A
Power B
Status
Bypass
OL-26790-01
SCE 1000 Ports
Quantity Description
2 10/100/1000 Ethernet RJ-45 ports
for management of the SCE 1000.
CLI designation: interface
Management 0/1, 0/2.
1 RS-232 RJ-45 port for use by
technicians
1 RS-232 RJ-45 port used by
technicians
2 Gigabit Ethernet ports for
connecting to the line
CLI designation: interface Gigabit
Ethernet 0/1 and 0/2
SCE 1000 LED Groups
Description
Continuous green - Power supply A is functioning normally
•
Red - Power supply A present, but malfunctioning
•
Unlit - Power supply A is either not present or has failed.
•
Continuous green - Power supply B is functioning normally
•
Red - Power supply B present, but malfunctioning
•
Unlit - Power supply B is either not present or has failed.
•
The Status LED indicates the operational status of the SCE 1000 system, as follows:
• Unlit - indicates no power from either power unit.
• Orange - indicates that the system is booting up.
Flashing green - indicates that the system is fully operational.
•
Flashing orange - indicates that the system is operational, but is in a warning state.
•
Red - indicates that there is a problem or failure
•
Note that Alarms are hierarchical: Failure takes precedence over Warning, which takes
precedence over operational.
Continuous green - indicates that the traffic bypasses the SCE 1000 through an
•
internal electrical bypass module.
The SCE 1000 is either in bypass or sniffing mode
Unlit - traffic is not being bypassed Indicates normal operation of the SCE 1000
•
Connect This Port To...
A LAN using an FE cable with an
RJ-45 connector.
If both interfaces are used to
provide a redundant management
interface, connect both ports to the
LAN via a switch.
A local terminal (console) using an
RS-232 cable with an RJ-45
connector, as provided in the SCE
1000 kit.
Refer to Cabling Diagrams for
cabling diagrams for various
topologies
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Front Panel
2-3