Step 4: Configuring Time Settings - Cisco SCE 1000 Installation And Configuration Manual

Step 4: Configuring Time Settings

Step 4: Configuring Time Settings

The time settings menu configures all time and date related parameters in the system. The time settings
menu includes the following:
•
•
•
•
You must enter the time setting menu to configure SNTP settings. You may choose to skip the time
settings menu if you wish to accept all default values.
Unlike all other settings defined in the system configuration, setting the time is done immediately and
Note
not at the end of the setup process.
Enter the time settings menu.
Step 1
Would you like to enter the Time settings menu? [no]: y
Type y and press Enter.
Configure the time zone name.
Step 2
Type the time zone abbreviation and press Enter.
Enter time zone name [UTC]: CET
Specify the offset from UTC.
Step 3
Type the minutes offset from UTC and press Enter.
Enter time zone minutes offset from UTC: 60
Confirm the local time and date.
Step 4
The local time and date are displayed, and you are asked whether you want to change them.
The local time and date is 15:00:01 CET FRI 01 July 2002
Would you like to set a new time and date? [no]:
•
•
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-10
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Time zone
Local time
Date
SNTP menu
If the time and date are correct, press Enter and go to Step 5: Configuring the DNS Settings.
If the time and date are not correct, answer yes to the above question, and press Enter.
Would you like to set a new time and date? [no]: y
Confirm your response and type the new time and date.
This change will take effect immediately both on the system clock and calendar; it
will also set the time zone you entered. Are you sure? [yes/no]: y
Enter new local time and date: 14:00:01 1 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
OL-26790-01