Fiber Specifications; How To Cable The Gbe Port - Cisco SCE 1000 Installation And Configuration Manual

Chapter 6 Cabling the Line Ports and Completing the Installation

Fiber Specifications

Table 6-1
Single Mode transceivers The transceiver type is indicated on the front panel under the ports. Note that
both transceivers on any individual SCE 1000 are the same, either 850nm Multimode or 1310nm Single
Mode.
Table 6-1
SCE Model
SCE 1000 2xGBE
MM
SCE 1000 2xGBE
SM

How to Cable the GBE Port

Class 1 laser. Avoid exposure to radiation and do not stare into open aperture.
Note
Take the appropriate fiber optic cable (see
Step 1
GBE port on the front panel of the SCE 1000
Make sure to push on the connector until you hear a click, which indicates that the connector is fully
inserted and secured in the receptacle. Always make sure that you insert the connector completely into
the socket.
Figure 6-3
OL-26790-01
presents the fiber specifications. The SCE 1000 may be ordered with either Multimode or
Fiber Specifications
Transceiver
850nm Multimode SCE 1000 2xGBE
1310nm FRP laser
Single Mode
Cabling the GBE Port
PW R A
PW R B
ST AT US
BY PA SS
MN G 1
MN G 2
CO NS OL
E
AU X LIN K RX
LIN K/
10/ 100 / TX
AC TIV E
LIN K/
100 0 10/ 100 /
AC TIV E
100 0
RX
MM
SU B
Transmit Power
MM 850nm
Multimode -9.5 to
-4 dBm
-9.5 to -3 dBm
Fiber Specifications, page
(Figure 6-3).
C is c o S
C E 1 0 0 0
S er ie s
2 x G B E
LIN K RX
TX
TX
RX
MM
TX
GB E-1
LIN E
NE T
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Connecting the GBE Line Interface Ports
Typical (Max.)
Receive Power Distance
-17 to 0 dBm 750m for
•
50µm Core
Diameter
MMF
400m for
•
62.5µm Core
Diameter
MMF
-20 to 3 dBm 10 km for 9.0µm
Core Diameter
SMF
6-5) and plug it into the appropriate
6-5