Ed-Stsn; Ed-Vt1 - Cisco ONS 15454 Reference Manual

Chapter 2 Procedures and Provisioning

2.2.2.5 ED-STSn

When the ED-STSn command is issued for a TACC it assigns the STS for the first two-way test access
connection and STS+1 as the second 2-way connection. For STS3c, STS9c, STS12c, STS24c, and
STS48c the next consecutive STS of same width is chosen. The TAP creation will fail if either of the
consecutive STSs are not available.
The command in
Example 2-4
These STSs cannot be used for the creation of cross-connects until the TAP is deleted.
Note
The command in
Example 2-5
These STSs cannot be used for the creation of cross-connects until the TAP is deleted.
Note

2.2.2.6 ED-VT1

When the ED-VT1 command is issued for a TACC, a VT TAP is created. The specified VT AID is taken
as the first VT connection, the second VT connection is made by incrementing the VT group and keeping
the VT number the same.
The command in
Example 2-6
These VTs cannot be used for the creation of cross-connects until the TAP is deleted.
Note
Example 2-4 creates a TAP on STS-5-1 and STS-5-2.
ED-STS1::STS-5-1:12:::TACCC=4
DV9-99 1970-01-02 03:16:11
M 12 COMPLD
;
Example 2-5 creates an STS24C dual TAP on STS-6-1 and STS-6-25.
ED-STS24C::STS-6-1:12:::TACC=5:
DV9-99 1970-01-02 03:16:11
M 12 COMPLD
;
Example 2-6 creates a VT TAP on VT1-1-1-1-1 and VT1-1-1-2-1.
ED-VT1-1-1-1-1:12:::TACC=6;
DV9-99 1970-01-02 03:16:11
M 12 COMPLD
;
2.2.2 TAP Creation and Deletion
Cisco ONS SONET TL1 Command Guide, R6.0
2-9