1-Way Circuit Single Roll And Dual Roll Procedures; Create A 1-Way Circuit Single Roll - Cisco ONS 15454 Reference Manual

2.8.4 1-Way Circuit Single Roll and Dual Roll Procedures

Table 2-7
Paths
VT#2 on STS#3
STS#4
Step 2 If you performed a manual roll, you must confirm the circuit is valid by issuing the
RTRV-BULKROLL-<OCN_TYPE> command:
Input Format:
RTRV-BULKROLL-<OCN_TYPE>:[<TID>]:<SRC>:<CTAG>;
Input Example:
RTRV-BULKROLL-OC12:CISCO:FAC-3-1:1;
2.8.4 1-Way Circuit Single Roll and Dual Roll Procedures
Single roll operation moves either the source or destination of a circuit to a new endpoint:
•
•
In single roll operation you only choose one roll point during the process.
Dual roll operation reroutes a segment between two roll points of a circuit. The new route can be:
•
•
•

2.8.4.1 Create a 1-Way Circuit Single Roll

To create a 1-way circuit single roll, enter the ENT-ROLL-<MOD_PATH> command or the
ENT-BULKROLL-<OCN_TYPE> command depending on the type of roll you want to perform.
Input Formats:
•
•
Cisco ONS SONET TL1 Command Guide, R6.0
2-56
2-Way Circuit Single or Dual Bulk Roll with ENT-BULKROLL (continued)
Before Roll
VT1-5-1-3-2-4
STS-5-1-4
Onto the same node or
Onto a different node
Anew link (no circuit is required), or
Another circuit (created before or during the bridge and roll process.
In dual roll operation, you choose two roll points during the process.
ENT-ROLL-<MOD_PATH>:[<TID>]:<FROM>,<TO>:<CTAG>:::RFROM=<RFROM>,
RTO=<RTO>,RMODE=<RMODE>,[CMDMDE=<CMDMDE>];
For a 1-way destination roll, the roll mode must be manual (MAN).
Note
ENT-BULKROLL-<OCN_TYPE>:[<TID>]:<FROM>:<CTAG>:::RTOSTART=<RTOSTART>,
[RFROMSTART=<RFROMSTART>],[RFROMEND=<RFROMEND>],RMODE=<RMODE>,
[CMDMDE=<CMDMDE>];
Chapter 2 Procedures and Provisioning
After Roll
VT1-6-1-3-2-4
STS-6-1-4