Retrieve Test Access Point Information; Rtrv-<Rr - Cisco ONS 15454 Reference Manual

Chapter 2 Procedures and Provisioning
Error codes supported:
SRCN—Requested condition already exists
SRAC—Requested access configuration is invalid
RTEN—Requested TAP does not exist
The command in
Example 2-8
The access mode cannot be changed if the TAP is not connected.
Note
This command generates a REPT DBCHG message.
Note

2.2.5 Retrieve Test Access Point Information

2.2.5.1 RTRV-<rr>
Note A generic ALL AID would behave similarly to an ALL AID such as, SLOT-ALL or FAC-1-ALL for all
the RTRV-rr commands that support a generic ALL AID.
The RTRV-<rr> command retrieves TAP information.
Input Format: RTRV-(T1, T3, STS1, STS3C, STS6C, STS9C, STS12C, STS24C, STS48C, STS192c,
VT1, DS1):[<TID>]:<AID>:<CTAG>;
This command is modified to include the return of a TAP number if the requested <AID> is defined as
a TAP. An optional TACC=<TAPNUMBER> will appear in the output list if the requested <AID> is
defined as a TAP.
Example 2-9
Parameter definitions:
•
•
•
Example 2-8
CHG-ACCMD-T1::1:12::LOOPE;
DV9-9 1970-01-02 02:59:43
M 12 COMPLD
;
RTRV-T1::FAC-1-1:12;
dv9-99 1970-01-02 02:49:16
M 12 COMPLD
"FAC-1-1::LINECDE=AMI,FMT=D4,LBO=0-131,TACC=1,TAPTYPE=DUAL:OOS"
;
<TID> the node name which is optional
<TAP> number from 1–999 identifying the TAP. Returned by the CONN-TACC command. If a TAP
is 0, the TAP is deleted. <TAP> is an integer
<CTAG> required identifier or number limited to six ASCII characters that correlates a response
with a command
changes the access mode of TAP 1 to LOOPE.
Cisco ONS SONET TL1 Command Guide, R6.0
2.2.5 Retrieve Test Access Point Information
2-11