Cisco ONS 15454 Reference Manual page 151

Chapter 3 TL1 Errors
3.1 Errors
Table 3-58 SROF Errors (continued)
SROF Error Messages
Cannot Access 1+1 Line
Cannot Access 1+1 Protected Line
Cannot Access 2 Fiber BLSR
Cannot Access 4 Fiber BLSR East Protection
Cannot Access 4 Fiber BLSR West Protection
Cannot Access 4F BLSR
Cannot Access Alarm Log
Cannot Access BLSR 2 Wire Line
Cannot Access BLSR 2-Wire Line
Cannot Access BLSR
Cannot Access Cross-Connection
Cannot Access DCC
Cannot Access Facility
Cannot Access PM Mode
Cannot Access Performance Monitoring Statistics
Cannot Access Protected Equipment
Cannot Access Protection Group Information
Cannot Access Protection Group Name
Cannot Access Protection Group Reversion Information
Cannot Access Reversion Information
Cannot Access STS
Cannot Access TAP
Cannot Access Unprotected Line
Cannot Access Unprotected Line
Cannot Access VT
Cannot Add Equipment
Cannot Add Equipment
Cannot Change BITS Configuration When Manual Switch Exists
Cannot Change Equipment Type
Cannot Change Ethernet IP With DHCP Provisioned
Cannot Change Ethernet IP With OSPF Provisioned
Cannot Change Parameter When User Switch Exists
Cannot Change Payload When Regeneration Group Exist
Cannot Change Port State When User Switch Exists
Cannot Change Synchronization Configuration When Manual Switch Exists
Cannot Change Threshold Values On Protect Card
Cisco ONS SONET TL1 Command Guide, R6.0
3-31