Activating New Software; Activate New Software - Cisco ONS 15454 Reference Manual

2.6.5 Activating New Software

If the TL1 session times out during download or if the user terminates the TL1 session the download will
Step 10
continue. The download completion can be confirmed by issuing the RTRV-NE-GEN command and
verifying the PROTLOAD.
Example 2-41 RTRV-NE-GEN:::1;
REPT EVT FXFR confirms the completion of the software download.
Step 11
Example 2-42
The SFTDOWN alarm clears when the download is complete.
Step 12
Example 2-43
2.6.5 Activating New Software
After the software is successfully downloaded, the new software which resides in the protect load must
be activated to run on the NE. The APPLY command can be used to activate and revert depending on the
version of the protect software and the newly downloaded software (see the
page 2-44

Activate New Software

If the protect software is newer than the working software, activate it as shown:
Step 1
Example 2-44 APPLY::1::ACT;
An error is reported if a revert is attempted with a newer protect software.
Cisco ONS SONET TL1 Command Guide, R6.0
2-48
A 2820,2820 REPT EVT FXFR
"ACTIVE,IP ,,80"
;
VA454-94 1970-01-06 22:22:12
M 1 COMPLD
"IPADDR=10.82.87.94,IPMASK=255.255.255.224,DEFRTR=10.82.86.1,
ETHIPADDR=10.82.87.94,EHTIPMASK=255.255.254.0,NAME=VA454-94,
SWVER=3.40.00,LOAD=03.40-002G-14-21,PROTSWVER=4.00.00,
PROTLOAD=03.40-X02E-28.04,DEFDESC=\:FACTORY DEFAULTS\""
;
DEV208 1970-01-10 12:01:16
A 2825,2825 REPT EVT FXFR
"ACTIVE,COMPLD,SUCCESS"
;
DEV208 1970-01-10 11:52:15
* 2826,2817 REPT ALM EQPT
"SLOT-7:CL,SFTWDOWN,NSA,,,,:\"SOFTWARE DOWNLOAD IN PROGRESS\" ,TCC"
;
for correct APPLY syntax).
DEV208 1970-01-10 13:40:53
M 1 COMPLD
;
Chapter 2 Procedures and Provisioning
"2.6.2 APPLY" section on