Provisioning Rules For Transponder And Muxponder Cards; Ppm Provisioning Rules; Payload Provisioning Rules - Cisco ONS 15454 Reference Manual

Chapter 2 Procedures and Provisioning
The TL1 interface does not support the autoprovision option for the
DS3/DS3E/DS3XM/DS3I/DS1cards; it only supports unframed, M23, or CBit. If autoprovision is
selected from CTC and at the same time the TL1 command RTRV-T3 is issued, the TL1 output will
indicate the FMT field as unframed during the time period that the card (if present) is autosensing the
frame format. If the card is not present (preprovisioned), the response of the RTRV-T3 command (after
CTC sets the FMT to autoprovision) will indicate the FMT field as unframed.

2.12 Provisioning Rules for Transponder and Muxponder Cards

This section provides provisioning rules associated with the following cards and pluggable port modules
(PPMs):
•
•
•
•

2.12.1 PPM Provisioning Rules

Card must be provisioned.
TL1 commands are:
•

2.12.2 Payload Provisioning Rules

1.
2.
3.
MXP_2.5G_10G/TXP_MR_10G
TXP_MR_2.5G/TXPP_MR_2.5G
MXP_2.5G_10E/TXP_MR_10E
MXP_MR_2.5G/MXPP_MR_2.5G
ENT/DLT-EQPT
Example of provisioning PPM on Slot-2, first PPM:
ENT-EQPT::PPM-2-1:100::PPM-1PORT;
PPM must first be provisioned.
Changing the payload data type requires:
All ports being edited must be in the OOS-MA,DSBLD state because this change is service
a.
affecting.
b. All ports being edited must not have any DCC terminations.
All ports being edited must not be part of any timing source.
c.
The section trace mode of all ports being edited must be OFF.
d.
For all regeneration and retiming (2R) payload types, trunk ports must not have GCC
e.
termination or OTN/FEC enabled.
The payload cannot be changed if any ports being edited are part of a Y-cable protection group.
f.
Only the TXP card can be used for the 10GigE payload. Termination mode must be set to
g.
Transparent-AIS or Transparent-Squelch (TXP_MR_10E only).
To set the payload to a speed other than OC-3/OC-12/OC-48/OC-192, the termination mode must
be set to Transparent-AIS or Transparent-Squelch (TXP_MR_10E only). For Fibre Channel cards
and all 2R payload types, the termination mode is not applicable and must be set to Transparent (AIS
or Squelch).
2.12 Provisioning Rules for Transponder and Muxponder Cards
Cisco ONS SONET TL1 Command Guide, R6.0
2-69