Scheduled Pm Report; Create A Pm Schedule And Receive An Autonomous Pm Report - Cisco ONS 15454 Reference Manual

2.7 Scheduled PM Report

Example 2-48 APPLY:NODE1::1::ACT;
2.7 Scheduled PM Report
The scheduled performance monitoring (PM) report is a feature that extends the capability of PM
reporting for the Cisco ONS 15454, ONS 15327, ONS 15310-CL and ONS 15600. With scheduled PM
report the system automatically and periodically generates the PM report of any specified facility or
cross-connection.
Note •
•
•
•
•

2.7.1 Create a PM Schedule and Receive an Autonomous PM Report

1.
2.
Cisco ONS SONET TL1 Command Guide, R6.0
2-50
APPLY:NODE2::1::ACT;
APPLY:NODE3::1::ACT;
APPLY:NODE4::1::ACT;
APPLY:NODE5::1::ACT;
The current maximum number of schedules allowed to be created for an NE is 1000. If this number
of schedules has been created for the NE, an error message "Reach Limits Of MAX Schedules
Allowed. Can Not Add More" will be returned if trying to create more schedules on the NE.
Identical schedules for an NE is not allowed. Two schedules are considered identical if they have
the same AID, MOD2 type, performance monitor type, performance monitor level, location,
direction and time period.
An error message "Duplicate Schedule" is returned if you create a schedule which is a duplicate of
an existing schedule. However, if the existing schedule expires (with the parameter <NUMINVL>
equal to zero when retrieved by the RTRV-PMSCHED command which means no more performance
monitoring report to be sent), then the new schedule with the identical parameter will replace the
existing schedule.
When you create a PM schedule, the minimum report interval should not be less than five minutes.
Refer to the Cisco ONS SONET TL1 Command Guide for complete command and autonomous
message information.
Issue the SCHED-PMREPT-<MOD2> command to create a PM schedule.
Issue the ALW-PMREPT-ALL command to allow the current TL1 session to be able to receive the
autonomous PM report.
Chapter 2 Procedures and Provisioning