Termination Mode Provisioning Rules; Wavelength Provisioning Rules - Cisco ONS 15454 Reference Manual

2.12.4 Termination Mode Provisioning Rules

2.12.4 Termination Mode Provisioning Rules
1.
2.
3.
4.
5.
6.
The TL1 commands are:
•

2.12.5 Wavelength Provisioning Rules

1.
2.
3.
4.
The TL1 commands are:
•
Cisco ONS SONET TL1 Command Guide, R6.0
2-72
This is a card-level operation.
Only applicable to payload types: OC-3/OC-12/OC-48/OC-192.
Changing termination mode requires:
All ports must be in OOS state because this change is traffic-affecting.
a.
All ports must not have DCC termination (GCC is not applicable).
b.
The Section Trace Mode on all ports must be OFF>.
c.
The trunk port must not be part of any timing source.
d.
If any port is Y-cable protected, rules a. to d. are applied to the peer's slot.
e.
Section and line termination mode is supported for the following payloads:
OC-3/OC-12/OC-48/OC-192.
You cannot change the termination mode if the port is part of a Y-cable protection or regeneration
group.
Termination mode provisioning does not apply to the MXP_MR_2.5G and MXPP_MR_2.5G cards.
ENT/ED-EQPT
Examples of setting termination mode:
ED-EQPT::SLOT-1:116:::CARDMODE=DWDM-LINE;
Changing trunk wavelength requires:
All trunk ports must be in the OOS state because this change is service-affecting.
a.
Setting the wavelength to the first tunable wavelength will cause the first wavelength from the card
manufacturing data to be used as the operational wavelength.
If the provisioned wavelength is set to the first tunable wavelength, any removal of an operational
card and subsequent replacement with a card for a different wavelength will not cause a mismatch
alarm to be raised.
To receive the mismatch alarm notification, you need to explicitly provision the wavelength and not
use the first tunable wavelength.
ENT/ED-EQPT
Example of setting card-level wavelength:
ED-EQPT:VA454-22:SLOT-1:116:::PWL=1530.33;
Chapter 2 Procedures and Provisioning