Chapter 3
TL1 Errors
Table 3-46
SDNA Error Messages
Active TCC Not Ready
Standby TCC Not Ready
Table 3-47
SNCC Error Messages
Cross connection does not exist
Path Roll Does Not Exist
Replace This Message When A SNCC message is needed
Table 3-48
SNCN Error Messages
Bad Quality
Cannot Switch To Bad Reference
Cannot Switch To Inferior Reference Source
Command Not Implemented
Cross-Connection Type Not Supported In TL1
Invalid Clock Source
Requested Direction Not Supported
STS Rate Change Not Supported
Sync Switch Operation Failed, Reference In OOS
Table 3-49
SNNS Error Messages
Reference Not From Optical Card
Table 3-50
SNOS Error Messages
Cannot Change Card Wavelength With Port(s) Not In OOS,DSBLD State
Cannot Change Payload With Port(s) Not In OOS State
Cannot Change Payload With Port(s) Not In OOS-MA,DSBLD State
Cannot Change Termination Mode With Port(s) Not In OOS State
SDNA Errors
SNCC Errors
SNCN Errors
SNNS Errors
SNOS Errors
Cisco ONS SONET TL1 Command Guide, R6.0
3.1 Errors
3-27