Chapter 3 Tl1 Errors; Errors; Table 3-1 Eneq Errors - Cisco ONS 15454 Reference Manual

TL1 Errors
The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
Note
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter provides TL1 error information supported by the Cisco ONS 15454, ONS 15327,
ONS 15600 and ONS 15310-CL. For alarm information, Refer to the platform-specific
Cisco ONS Procedure Guide, Cisco ONS Troubleshooting Guide and Cisco ONS Reference Manual.

3.1 Errors

Errors can be generated by any command or command response message.
list errors alphabetically by error code. The format of an error message is as follows:
SID DATE TIME
M CTAG DENY
<ERRCDE>
/* <ERRMSG> */
;
Table 3-1
ENEQ Error Messages
At Least One Equipment Is Not Plugged
Communication Failed
Control Not Provisioned
Cost Not Found
EnvControl IF Is Not Found
Environmental Control Interface Not Found
Equipment Is Deleted
Equipment Must Be Present
Equipment Not Found
ENEQ Errors
C H A P T E R
Table 3-1
Cisco ONS SONET TL1 Command Guide, R6.0
3
through Table 3-64
3-1