Dlt-Rmonth-<Mod2_Rmon; Rtrv-Rmonth-<Mod2_Rmon - Cisco ONS 15454 Reference Manual

Chapter 2 Procedures and Provisioning
2.10.3 DLT-RMONTH-<MOD2_RMON>
The DLT-RMONTH-<MOD2_RMON> command deletes a threshold type (an entry in the RMON alarm
table) created for a montype (RMON statistic type). Because there can be multiple thresholds created for
a particular montype, you must specify all the necessary parameters for the threshold, in order to identify
the particular threshold to be deleted.
This command applies to G1000, GIGE, FSTE, POS, and FC data objects.
Input Format DLT-RMONTH-<MOD2>:[<TID>]:<AID>:<CTAG>::<MONTYPE>,,,,<INTVL>:RISE=<RISE>,
FALL=<FALL>,[SAMPLE=<SAMPLE>,][STARTUP=<STARTUP>][:];
Input Example The following example deletes an entry in the RMON threshold table for the etherStatsOctets statistic
type, with an interval equal to 100 seconds, rising threshold of 1000, falling threshold of 100, DELTA
sampling type, and the startup type of BOTH.
DLT-RMONTH-GIGE:CISCO:FAC-2-1:123::ETHERSTATSOCTETS,,,,100:RISE=1000,FALL=100,
SAMPLE=DELTA,STARTUP=BOTH;
Table 2-13
Table 2-13
Error Code
IDNV
IDRG
IDNV
SROF
2.10.4 RTRV-RMONTH-<MOD2_RMON>
The RTRV-RMONTH-<MOD2_RMON> command retrieves the thresholds defined in the RMON alarm
table.
Input Format RTRV-RMONTH-<MOD2>:[<TID>]:<AID>:<CTAG>::[<MONTYPE>]>,,,,
[<INTVL>]:[RISE=<RISE>,][FALL=<FALL>,][SAMPLE=<SAMPLE>,][STARTUP=<STARTUP>];
shows the error messages associated with the DLT-RMONTH-<MOD2_RMON> command.
Error Messages for DLT-RMONTH-<MOD2_RMON>
Description
Invalid Interval
Invalid Threshold Value
Invalid MONTYPE value
RMON Threshold Does
Not Exist
2.10.3 DLT-RMONTH-<MOD2_RMON>
Scenario When the Error Message is Sent
The input interval value is less than 10.
The rising/falling threshold is less than 0, or the falling
threshold is greater than or equal to rising threshold.
The montype is not applicable to the data type
(represented by the MOD2).
The RMON threshold you are trying to delete does not
exist.
Cisco ONS SONET TL1 Command Guide, R6.0
2-63