3.1 Errors
Table 3-56
SRAC Error Messages
Invalid Connection Type
Requested Access Configuration is Invalid
Table 3-57
SRCN Error Messages
Already In Requested Mode
Area already exists on lan interface
Cannot use backbone area, lan active
Requested Condition Already Exists
Table 3-58
SROF Error Messages
1+1 Protection Group Not Found
1WAYMON not supported
2F BLSR Pool Not Available
4F BLSR EastProtect Pool Is Not Available
4F BLSR Pool Not Available
4F BLSR WestProtect Pool Is Not Available
AID Listing Not Allowed
ALL Rolls Failed
ALS Mode Does Not Allow Laser Restart
APC System Is Busy
APC System Is Not Enabled
Active Flash Not Ready
All DCCs In Use
All Link Terminations On Port Must Terminate On Same Remote Node
BFDL Mode Requires ESF Framing
BLSR In Use
BLSR Pool Not Available
BLSR Protect STS Path List Is Empty
BLSR Spans Are Not Locked
Bridge And Roll Not Supported On Roll From And/Or Roll To
CKTID Does Not Match
Can Not Get IOS Config Source Origin
Cisco ONS SONET TL1 Command Guide, R6.0
3-30
SRAC Errors
SRCN Errors
SROF Errors
Chapter 3
TL1 Errors