2-Way Circuit Single Roll And Dual Roll Procedures; Create A 2-Way Circuit Single Roll Or Dual Roll - Cisco ONS 15454 Reference Manual

2.8.3 2-Way Circuit Single Roll and Dual Roll Procedures

•
•
•
•
•
•
2.8.3 2-Way Circuit Single Roll and Dual Roll Procedures
Single roll operation moves either the source or destination of a circuit to a new endpoint:
•
•
In single roll operation, you only choose one roll point during the process.
Dual roll operation reroutes a segment between two roll points of a circuit. The new route can be:
•
•
•

2.8.3.1 Create a 2-Way Circuit Single Roll or Dual Roll

To create a 2-way circuit single roll or dual roll, enter the ENT-ROLL-<MOD_PATH> command or the
ENT-BULKROLL-<OCN_TYPE> command depending on the type of roll you want to perform.
Input Formats:
•
Cisco ONS SONET TL1 Command Guide, R6.0
2-54
ED-BULKROLL-<OCN_TYPE>
This command edits information about rolling traffic from one endpoint to another without
interrupting service. This command can use the CMDMDE option to force a valid signal. The only
parameter that can be edited is CMDMDE. The time slots cannot be edited. This commands supports
line-level rolling/bulk rolling and cannot be used for path-level rolling.
ED-ROLL-<MOD_PATH>
This command edits information about rolling traffic from one endpoint to another without
interrupting service. This command can use the CMDMDE option to force a valid signal. The only
parameter that can be edited is CMDMDE. The time slots cannot be edited.
ENT-BULKROLL-<OCN_TYPE>
This command enters information about rolling traffic from one endpoint to another without
interrupting service. This commands supports line level/bulk rolling and cannot be used for single
path-level rolling.
ENT-ROLL-<MOD_PATH>
This command enters information about rolling traffic from one endpoint to another without
interrupting service. This command supports STS and VT path-level rolling only.
RTRV-BULKROLL-<OCN_TYPE>
This command retrieves roll data parameters. This command supports line-level rolling/bulk rolling
and cannot be used for path-level rolling.
RTRV-ROLL-<MOD_PATH>
This command retrieves roll data parameters.
Onto the same node or
Onto a different node
A new link (no circuit is required), or
Another circuit (created before or during the bridge and roll process
In dual roll operation, you choose two roll points during the process.
ENT-ROLL-<MOD_PATH>:[<TID>]:<FROM>,<TO>:<CTAG>:::RFROM=<RFROM>,
RTO=<RTO>,RMODE=<RMODE>,[CMDMDE=<CMDMDE>];
Chapter 2 Procedures and Provisioning