Honda CR-V 1997 Service Manual page 1391

NOTE:
• Before installing the steering wheel, the front
wheels should be aligned straight ahead,
• 8e sure to install the harness wires so that they
are not pinched or interfering with other parts.
• After reassembly, confirm that the wheels are
still turned straight ahead and that the steering
wheel spoke angle is correct (road test). If minor
spoke angle adjustment is necessary, do so only
by adjusting the tie-rods, not by removing and
repositioning the steering wheel.
'1 , Set the cancel sleeve so that the projections are
aligned as shown.
CANCEL
SLEEVE
VERTICAL
CABLE REEL SUB
HARNESS
t
PROJECTIONS
.~;:!-'~/
3P [6PJ CONNECTOR
( J:
'98 - 00 model.
12. Carefully install the cable reel on the steering col-
umn shaft. Then connect the 3P l6P1 connector to
the cable reel sub harness, and connect the 2P con -
nector to the SRS main harness.
13. Install the steering column covers.
14. If necessary, center the cable reel. (New replace-
ment cable reels come centered.) Do this by first
rotating the cable reel clockwise until it stops. Then
rotate it counterclockwise (approximately two and a
half turns) until the arrow mark on the cable reel
label points straight up,
ARROW MARK
15. Install the steering wheel on to the steering column
shaft, making sure the steering wheel shaft engages
the cable reel and canceling sleeve. Do not tap on
the steering wheel or steering column shaft when
installing the steering wheel.
CABLE REEL
(cont'd)
24-93