Fuse; Power Management Modes; Power Controls; Power Switch - Honeywell Thor VM3 User Manual

Fuse

Power Management Modes

Power Controls

Power Switch

Power Button

External Connectors

Power the Thor VM3 off before attaching a cable to any port (serial, USB, Audio/CAN, etc.).
The external I/O connectors for the Thor VM3 are located on the right side of the Quick Mount Smart Dock (when viewed from
the back).
The Power Supply Connector
Antenna connectors are located on the top rear of the Thor VM3.
3 - 4
The Thor VM3 uses an 8A time delay (slow blow), fuse that is externally accessible and user
replaceable. The fuse is located on the back of the Quick Mount Smart Dock. The fuse is accessed
by unscrewing the cap as indicated.
Should it need replacement, replace with same size, rating and type of fuse:
• Littelfuse 0215008.MXP
• Cooper Bussmann BK1/S506-8-R
• Bel Fuse 5HT 8-R
or equivalent.
Fuse has voltage on it even when power is off. Always disconnect input power before changing the
fuse.
After all cables are connected, the Thor VM3 can be powered on.
There is a power switch located on the back of the Quick Mount Smart Dock. The power switch
is a rocker switch.
The power switch has a raised bump to identify the switch position even when it is hidden from
view. When the side of the switch with the raised bump is pressed, the power switch is On. If
the dock is connected to external power, the dock delivers power to the Thor VM3.
Generally, once the dock is powered On, there is no need to power it off. The dock power can
remain On even when the Thor VM3 is not attached.
(page 3-6) is on the left side of the dock (when viewed from the back).