Power Controls; External Connectors - Honeywell THOR VM1 User Manual

Power Controls

Power Switch
Power Button
Auto On Behavior
Select the desired Ignition Control / Auto On behavior.
The Thor VM1 Auto On options can be configured using the
tion for more details on the options below.
For information on the Ignition input signal see
Control Wiring Diagram
Standard
The Thor VM1 is turned on and off manually by the user using the power button on the front of the device.
Ignition Control
The Thor VM1 is turned on automatically when a signal is received via the Ignition Input wire, which is part of the
DC Power Cable.
Auto-On
The Thor VM1 automatically powers up when power is provided.

External Connectors

Power the Thor VM1 off before attaching a cable to any port (serial, USB, Audio/CAN, etc.).
The external I/O connectors for the Thor VM1 are located on the right side of the dock (when viewed from the back).
After all cables are connected, the Thor VM1 can be powered on.
There is a power switch located on the back of the dock. The power switch is a rocker
switch.
The power switch has a raised bump to identify the switch position even when it is hidden
from view. When the side of the switch with the raised bump is pressed, the power switch
is On. If the dock is connected to external power, the dock delivers power to the Thor VM1.
Generally, once the dock is powered On, there is no need to power it off. The dock power
can remain On even when the Thor VM1 is not attached.
The power button is located at the top left of the Thor VM1.
If the Thor VM1 is Off, pressing the power button starts the power up
sequence.
Note: This assumes that the Thor VM1 is docked in a powered dock
If the Thor VM1 is On, pressing the power button performs the option
selected in the Advanced tab of the Power control panel:
• Ignore power button press
• Prompt the user to select action
• Shut down (default, an orderly shutdown is performed)
• Standby
• Hibernate
Vehicle 10-60VDC Direct Power Connection
(page 4-35).
or that the internal UPS battery has a sufficient charge to
power the Thor VM1. If no external power is available and the
UPS battery does not have a charge, pressing the power
button causes no action.
AutoOn (page 5-5) control panel. Please refer to that sec-
(page 4-33) and Auto-On
3 - 5