Bar Code Readers; Scanner Wedge; Touch Screen Calibration - Honeywell Thor VM3 User Manual

Hide thumbs Also See for Thor VM3:

Table of Contents

Bar Code Readers

The Thor VM3 can use the following external bar code readers:

• Tethered hand-held scanners are tethered to a serial port or a USB host port (via a dongle cable) on the Thor VM3 Quick

Mount Smart Dock and are configured by scanning the engine-specific bar codes in the scanner manufacturer's programming

guide. The manufacturer's guides are usually shipped with the bar code reader.

• Wireless hand-held Bluetooth scanners are configured by scanning the engine-specific bar codes in the scanner

manufacturer's programming guide. The manufacturer's guides are usually shipped with the bar code reader.

• The body worn Bluetooth Ring Scanner module may be using a Symbol 4400 Ring Imager or a Symbol 955 Ring Scanner.

The BTRS module is configured by scanning the bar codes in the Bluetooth Ring Scanner Guide.

Honeywell provides Freefloat Link*One for bar code decoding needs on the Thor VM3. Refer to the

documentation on Freefloat Link*One.

Start > Programs > PenMount Windows Universal Driver

To calibrate the touch screen, tap Start > Programs > PenMount Universal Driver > Utility > PenMount Control Panel.

Select PenMount 6000 USB and then tap Configure. Select Standard Calibration or Advance Calibration.

Advanced Calibration allows the user to select the number of calibration points. With either option, follow the on screen

instructions to touch the red square, hold the touch and then lift the stylus to complete the calibration process.

2 - 24

Freefloat website

for

Table of Contents