Honda Prelude 1993 Service Manual page 1073

Hide thumbs Also See for Prelude 1993:

Table of Contents

Clutch Overhaul (cont'dl

Remove the snap ring A with a snap ring pliers.

Release the field coil connector from the connector

holder, and disconnect the connector and field coil

ground terminal.

Remove the field coil from the comDresso..

. Once the snap ring A is removed. replace it with

. When installing the field coil. align the boss on

the tield coil with the hole in the comDressor.

Position the rotor pulley squarely over the field coil.

Press the rotor pulley onto the compressor boss

with the soecial tool.

l f t h e r o t o r p u l l e y d o e s n o t p r e s s o n s t r a i g h t ,

remove it and check the rotor pulley and compres-

sor boss for burrs or damage,

CAUTION: Maximum press load: il00 kg (882 lbsl

REMOVER OTJAC _ SH2O3OO

7 . lnstall in the reverse order of removal, and:

. Clsan the rotor pulley and compressor sliding

surfacas with non-Detroleum solvent.

Install th6 snap rings with the chamfered side

facing out and make sure the snap rings are in

the groov€ complgtoly.

. After installing, mak€ sure that the rotor pulley

turns smoothly.

. Route and clamp the wir€s properly or they can

be damag6d by the rotor pulley.

Troubleshooting