Drive Plate Removal And Installation - Honda 2004 Odyssey Service Manual

Automatic Transmission
Transmission Removal (cont'd)
55. Lower the transmission, and tilt the engine just
enough for the transmission to clear its end cover
from the side frame.
56. Place a transmission jack under the transmission.
57. Pull the transmission away from the engine until it
clears the dowel pins, then lower it on the
transmission jack.
NOTE: If the torque converter is stuck to the drive
plate, pull it toward the transmission housing from
the starter opening.
58. Remove the shift cable cover, then remove the
torque converter assembly from the torque
converter housing.
59. Inspect the drive plate, and replace it if it's
damaged.
60. Remove the 6 x 1.0 x 14 mm bolt that you installed
on the shift cable cover in step 31.
14-146 14-146
Drive Plate Removal and
Installation
1. Remove the drive plate (A) and washer (B) from the
engine crankshaft
12 x 1.25 mm
74 N·m (7.5 kgf·m, 54 lbf·ft)
2. Install the drive plate and washer on the engine
crankshaft, and tighten the eight bolts in a
crisscross pattern.
A
B