6.2 Training screen creation
Bit lamp
Turns on during line operation
(M33)
Touch Switch
Will not operate if the Ready lamp
is not ON before the operation/stop
switch is pressed (N31).
6.2.1
Screen creation training
Add the following Base Screen No. 3 to the screen created in chapter 5.
Base Screen No. 3
[Operation of Base Screen No. 3]
1)
When the Preparation switch and the Operation/Stop switch turn ON, the
operation will start, and the lamp will be lit.
2)
As the operation gets started, the operating time starts counting. When the
operation time is over 8 hours, the lamp turns ON.
(1) Creating and setting Base Screen No. 3
(Next page)
1)
Create a base screen as follows:
1)
Screen number: 3
Screen Name: Operating time display
6 - 3
Numerical display
Displays the operation time of
line in seconds.
(D30,D31,D32,D33,D34)
Bit lamp
Lit if the operating display
exceeds 8 hours (N34).
Touch switch
Operation/stop switch (N31)
to activate the line
Screen switching switch
Return to Base screen No. 1