Appendix 3.2 Procedures Up To Accessing - Mitsubishi Electric Got 1000 Training Manual

Appendix 3.2 Procedures up to accessing

Connect the GOT to a Mitsubishi PLC.
Set the communication interface (Communication settings)
Attach the communication unit and connect the cable.
Access the PLC by GX Developer.
This section describes the system configurations using the following connection
examples:
• Connection between the PC and GOT: USB connection
• Connection between GOT and PLC: Bus connection
The following shows the procedure before accessing.
(1) Setting communication interface (Communication settings)
Set the communication interface of the GOT at [Communication settings] in GT
Designer2.
Refer to section (1).
Refer to section (2).
Refer to section (3).
1) Set [CH No.] of [Standard I/F-1] to "9".
2) Set [Driver] of [Standard I/F-1] to "Host(PC)".
Appendix 20