Training Screen Modification; Operation Check (2) - Mitsubishi Electric Got 1000 Training Manual

6.3.5

Training screen modification

6.3.6

Operation check (2)

Check the settings of touch switch (Operation/Stop) that turns on M31.
2)
Display the download screen of the project, and download all the data to the GOT.
Reset the PLC CPU using the RESET key switch, and then switch to RUN.
(1) Test
Perform the following tests in screen No. 3.
Test object
Item
1) Touch operation
Screen state
2) Touch operation
Screen state
Check the Operating lamp turns ON, and that the operating time counts up.
The correction of drawing data is completed.
Set the Ready switch OFF to perform the operation check in section 6.4.1.
1) Check the
(Operation/Stop) for Base Screen No.3.
M35 was mistakenly assigned, instead of
M32, for the device to be turned ON.
2) Change the settings of the Operation/Stop
switch as follows:
[Basic tab]
Device: M35 → M32
[Text/Lamp tab]
Lamp: Bit, M35 → M32
Copy OFF → ON
Touch Ready, and then touch Operation/Stop.
The Operating lamp turns ON, and the operating time
starts counting.
Touch Operation/Stop.
The Operating lamp turns OFF, and the operating time
stops.
↓
6 - 16
settings of touch
Operation
switch